APRS Track Direct

My position About ☰

reset

VK2WIR-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK2WIR-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274604	136	31	125	100	86
1762335262	126	21	127	106	94
1762334421	127	22	127	105	94
1762333580	128	22	127	105	93
1762332739	129	23	126	105	93
1762331899	130	24	126	104	92
1762331057	131	25	126	104	91
1762330216	133	26	126	103	90
1762329375	134	27	126	102	90
1762328534	135	27	126	102	89
1762327693	135	28	125	101	88
1762326852	135	29	125	101	88
1762326011	135	30	125	101	87
1762325170	136	30	125	100	86
1762324329	135	31	125	100	86
1762323488	135	31	125	100	86
1762322647	135	32	125	99	86
1762321806	135	33	124	99	84
1762320965	136	34	124	98	83
1762320124	135	37	123	96	80
1762319283	136	41	122	94	77
1762318442	136	45	121	91	74
1762317602	136	48	120	88	70
1762316760	136	49	120	88	70
1762315919	136	49	121	89	71

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)