APRS Track Direct

My position About ☰

reset

F6DAY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6DAY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790665018	649 Count	557 Count	403 Count
1790664054	645 Count	553 Count	400 Count
1790663090	641 Count	549 Count	397 Count
1790662126	639 Count	547 Count	396 Count
1790661162	635 Count	543 Count	393 Count
1790660772	634 Count	543 Count	393 Count
1790659808	631 Count	540 Count	391 Count
1790658844	628 Count	538 Count	389 Count
1790657878	624 Count	534 Count	386 Count
1790656914	620 Count	530 Count	383 Count
1790655950	616 Count	526 Count	380 Count
1790654986	613 Count	523 Count	378 Count
1790654022	610 Count	520 Count	376 Count
1790653058	607 Count	517 Count	374 Count
1790652094	604 Count	515 Count	372 Count
1790651130	600 Count	512 Count	369 Count
1790650166	599 Count	512 Count	369 Count
1790649202	596 Count	509 Count	367 Count
1790648238	594 Count	507 Count	366 Count
1790647274	590 Count	503 Count	363 Count
1790646309	586 Count	499 Count	360 Count
1790645345	584 Count	497 Count	359 Count
1790644381	580 Count	493 Count	356 Count
1790643417	578 Count	491 Count	355 Count
1790642453	575 Count	489 Count	353 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)