APRS Track Direct

My position About ☰

reset

ED1YBD-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED1YBD-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786726430	51	28	72	191	162
1786725529	50	27	72	191	162
1786724628	49	25	72	191	162
1786723727	43	22	72	191	162
1786722827	40	20	72	192	162
1786721926	45	22	72	192	162
1786721025	49	23	71	192	162
1786720124	52	25	71	191	162
1786719223	53	26	71	192	162
1786718322	49	24	71	192	163
1786717421	43	22	71	192	163
1786716521	42	22	71	192	165
1786715620	43	22	71	192	165
1786714720	44	22	71	192	166
1786713819	45	24	71	192	167
1786712917	47	25	71	192	169
1786712017	49	26	71	192	168
1786711115	48	25	71	192	168
1786710214	46	22	71	192	168
1786709314	47	21	71	192	167
1786708413	48	21	71	192	167
1786707512	55	23	71	191	168
1786706611	61	24	71	192	168
1786705711	61	25	71	186	168
1786704809	60	24	71	187	168

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)