APRS Track Direct

My position About ☰

reset

SP3NGH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3NGH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782482920	926 Count	404 Count	25 Count
1782481119	922 Count	404 Count	25 Count
1782479318	918 Count	404 Count	25 Count
1782477516	910 Count	404 Count	25 Count
1782475715	903 Count	404 Count	25 Count
1782473915	899 Count	404 Count	25 Count
1782472113	895 Count	404 Count	25 Count
1782470312	891 Count	404 Count	25 Count
1782468510	887 Count	403 Count	25 Count
1782466709	883 Count	395 Count	25 Count
1782464908	870 Count	387 Count	25 Count
1782463107	866 Count	383 Count	25 Count
1782461306	862 Count	381 Count	25 Count
1782459505	852 Count	381 Count	25 Count
1782457704	843 Count	381 Count	25 Count
1782455903	827 Count	381 Count	25 Count
1782454101	800 Count	381 Count	25 Count
1782452300	781 Count	381 Count	25 Count
1782450499	767 Count	380 Count	24 Count
1782448699	742 Count	380 Count	24 Count
1782446898	732 Count	379 Count	24 Count
1782445121	728 Count	360 Count	24 Count
1782443320	721 Count	303 Count	21 Count
1782441519	711 Count	248 Count	15 Count
1782439718	707 Count	244 Count	15 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)