APRS Track Direct

My position About ☰

reset

SR9EMP-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1786729774	16 Count	804 Count
1786727974	14 Count	669 Count
1786726173	11 Count	550 Count
1786724372	8 Count	416 Count
1786722571	5 Count	277 Count
1786720770	2 Count	142 Count
1786718970	19 Count	1002 Count
1786717158	15 Count	786 Count
1786715365	12 Count	624 Count
1786713563	8 Count	460 Count
1786711763	5 Count	325 Count
1786709962	2 Count	123 Count
1786708162	24 Count	1066 Count
1786706360	20 Count	902 Count
1786704560	17 Count	763 Count
1786702759	13 Count	595 Count
1786700959	10 Count	474 Count
1786699157	6 Count	314 Count
1786697357	4 Count	179 Count
1786695555	0 Count	0 Count
1786693765	21 Count	890 Count
1786691963	16 Count	669 Count
1786690163	13 Count	544 Count
1786688362	9 Count	339 Count
1786686562	6 Count	194 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)