APRS Track Direct

My position About ☰

reset

VK2RWK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK2RWK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732304235	133	24	122	104	89
1732303346	133	24	122	104	89
1732302456	133	25	122	103	88
1732301567	133	25	122	103	88
1732299788	133	25	122	104	89
1732298898	133	25	122	103	88
1732298009	133	25	122	104	89
1732297119	133	24	122	103	88
1732296230	133	25	122	103	88
1732295340	133	25	121	103	88
1732294450	133	25	122	104	89
1732293561	133	25	121	103	88
1732292671	132	25	122	103	88
1732291781	133	25	122	104	89
1732290892	133	25	122	103	88
1732290002	133	25	122	103	89
1732289113	127	25	121	103	89
1732288112	133	25	122	103	88
1732287222	133	25	122	104	89
1732286333	133	25	121	102	87
1732285443	132	25	122	103	89
1732284554	133	25	122	103	87
1732283664	133	26	122	103	88
1732282774	133	26	122	103	88
1732281885	133	26	122	103	88

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)