APRS Track Direct

My position About ☰

reset

CLIMAX Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CLIMAX. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1782483447	126	41	75	42	63
1782472513	125	20	93	42	59
1782468873	126	21	69	42	49
1782465238	126	19	103	43	71
1782461595	126	40	68	42	50
1782457965	127	20	68	42	50
1782454334	127	21	66	42	50
1782450690	128	18	69	42	50
1782447060	128	23	66	50	49
1782443424	128	22	63	42	50
1782439792	129	22	63	42	50
1782436164	130	22	61	42	50
1782432535	133	22	61	42	49
1782428899	140	22	61	42	50
1782425264	140	24	61	42	50
1782421634	138	21	63	42	50
1782417997	143	22	63	42	50
1782414347	131	21	66	42	50
1782410705	129	20	68	42	49
1782407038	126	36	68	42	49

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)