APRS Track Direct

My position About ☰

reset

HB9EZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9EZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1774079731	417 Count	994 Count	158 Count
1774078903	416 Count	993 Count	158 Count
1774078000	414 Count	989 Count	157 Count
1774077097	413 Count	986 Count	157 Count
1774076194	411 Count	983 Count	156 Count
1774075291	410 Count	980 Count	156 Count
1774074388	409 Count	977 Count	156 Count
1774073485	407 Count	975 Count	155 Count
1774072582	405 Count	971 Count	154 Count
1774071679	403 Count	968 Count	153 Count
1774070776	402 Count	966 Count	153 Count
1774069873	401 Count	963 Count	153 Count
1774068970	399 Count	960 Count	152 Count
1774068066	398 Count	958 Count	152 Count
1774067163	396 Count	954 Count	151 Count
1774066260	395 Count	952 Count	151 Count
1774065357	393 Count	949 Count	150 Count
1774064453	391 Count	946 Count	149 Count
1774063550	390 Count	944 Count	149 Count
1774062647	388 Count	941 Count	148 Count
1774061744	386 Count	938 Count	147 Count
1774060841	385 Count	936 Count	147 Count
1774059938	383 Count	933 Count	146 Count
1774059035	382 Count	931 Count	146 Count
1774058132	379 Count	927 Count	144 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)