APRS Track Direct

My position About ☰

reset

ED1ZAJ-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED1ZAJ-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Volt.*	Rx/h*	Digi/h*	Temp*	Efic*
1790646453	133	39	26	23	34
1790638354	134	33	23	21	36
1790634753	134	35	23	20	34
1790632953	134	42	29	40	36
1790625752	137	36	25	23	35
1790624224	135	34	23	21	35
1790617026	133	35	26	39	34
1790605052	133	32	23	22	34
1790601506	137	34	24	22	34
1790599652	136	35	25	23	34
1790594308	135	30	24	38	35
1790590706	134	37	25	23	35
1790585251	134	36	27	40	35
1790584564	131	36	25	23	35
1790583451	133	36	25	23	34
1790582551	134	38	28	40	35
1790581651	135	33	24	22	34
1790579851	135	42	29	23	34
1790578951	134	32	24	38	35
1790577151	134	33	26	40	36
1790576251	130	36	25	23	35
1790575351	132	36	25	22	35
1790574450	132	35	25	23	34
1790573551	132	39	26	23	34
1790572650	132	43	30	41	34

*Used Equation Coefficients:

Volt.: 0, 1, 0

Rx/h: 0, 1, 0

Digi/h: 0, 1, 0

Temp: 0, 1, 0

Efic: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)