APRS Track Direct

My position About ☰

reset

SP8PB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8PB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1782488725	463 Count	827 Count	306 Count
1782487825	460 Count	822 Count	304 Count
1782486924	458 Count	818 Count	303 Count
1782486023	456 Count	816 Count	302 Count
1782485123	453 Count	811 Count	300 Count
1782483321	424 Count	728 Count	273 Count
1782482420	422 Count	724 Count	272 Count
1782481520	420 Count	721 Count	271 Count
1782480619	418 Count	718 Count	270 Count
1782479718	415 Count	713 Count	268 Count
1782478817	412 Count	708 Count	266 Count
1782477917	409 Count	703 Count	264 Count
1782477017	406 Count	698 Count	262 Count
1782476115	403 Count	693 Count	260 Count
1782475215	400 Count	688 Count	258 Count
1782474314	397 Count	683 Count	256 Count
1782473413	395 Count	680 Count	255 Count
1782472513	393 Count	676 Count	254 Count
1782471612	390 Count	671 Count	252 Count
1782470711	387 Count	666 Count	250 Count
1782469810	384 Count	662 Count	248 Count
1782468909	381 Count	657 Count	246 Count
1782468009	379 Count	653 Count	245 Count
1782467108	377 Count	649 Count	244 Count
1782466207	374 Count	645 Count	242 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)