APRS Track Direct

My position About ☰

reset

EW1EM-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EW1EM-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Temp*
1786747765	12.45 Volt	32 C
1786747465	12.45 Volt	32 C
1786747165	12.45 Volt	32 C
1786746865	12.45 Volt	32 C
1786746565	12.45 Volt	32 C
1786746265	12.45 Volt	32 C
1786745965	12.45 Volt	32 C
1786745665	12.45 Volt	32 C
1786745365	12.45 Volt	32 C
1786745065	12.45 Volt	32 C
1786744765	12.45 Volt	32 C
1786744465	12.45 Volt	32 C
1786744165	12.45 Volt	32 C
1786743865	12.45 Volt	32 C
1786743565	12.45 Volt	32 C
1786743265	12.45 Volt	32.5 C
1786742965	12.45 Volt	32.5 C
1786742665	12.45 Volt	32.5 C
1786742365	12.45 Volt	32.5 C
1786742067	12.45 Volt	32.5 C
1786741765	12.45 Volt	32.5 C
1786741465	12.45 Volt	32.5 C
1786741165	12.45 Volt	32.5 C
1786740865	12.45 Volt	32.5 C
1786740565	12.45 Volt	32.5 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Temp: 0, 0.5, -64

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)