APRS Track Direct

My position About ☰

reset

EA4ATS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1778037412	15 Count	867 Count
1778035609	14 Count	797 Count
1778033806	13 Count	736 Count
1778032003	12 Count	680 Count
1778030199	11 Count	626 Count
1778028396	10 Count	579 Count
1778026593	9 Count	533 Count
1778024790	8 Count	478 Count
1778022987	7 Count	429 Count
1778021222	6 Count	379 Count
1778019419	5 Count	335 Count
1778017616	4 Count	283 Count
1778015813	3 Count	230 Count
1778014009	2 Count	170 Count
1778012205	1 Count	116 Count
1778010402	0 Count	64 Count
1778008599	14 Count	1032 Count
1778006796	13 Count	954 Count
1778004992	12 Count	875 Count
1778003189	11 Count	797 Count
1778001386	10 Count	728 Count
1777999622	9 Count	661 Count
1777997819	8 Count	614 Count
1777996015	7 Count	543 Count
1777994212	6 Count	482 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)