APRS Track Direct

My position About ☰

reset

VA3PEC Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VA3PEC. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274827	135	22	255	88	50
1836274224	135	22	255	88	50
1782542969	134	23	255	87	49
1782542359	134	23	255	86	49
1782541762	134	23	255	87	49
1782541158	134	23	255	87	49
1782540557	134	23	255	86	49
1782539953	134	23	255	86	49
1782539352	134	23	255	86	49
1782539047	134	23	255	85	48
1782538748	134	23	255	86	49
1782538146	134	23	255	85	48
1782537545	134	23	255	86	49
1782536943	134	23	255	86	48
1782536342	134	23	255	86	48
1782535741	134	23	255	86	49
1782535139	134	23	255	86	48
1782534538	134	23	255	86	48
1782533937	134	23	255	85	49
1782533334	134	23	255	85	48
1782532730	134	23	255	85	48
1782532129	134	23	255	85	48
1782531526	134	23	255	84	48
1782530924	134	23	255	85	48
1782530323	134	23	255	84	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)