APRS Track Direct

My position About ☰

reset

IZ1DNG Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ1DNG. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1770141574	147	208	236	243	171
1770141566	148	209	225	220	169
1770141555	147	208	236	236	166
1770141539	147	208	236	243	168
1770141465	147	209	225	220	168
1770141421	147	208	236	229	166
1770141410	147	209	225	234	169
1770141352	147	209	225	234	169
1770141253	147	207	227	220	169
1770141241	147	208	236	237	167
1770141122	148	209	224	231	167
1770140855	147	209	225	237	173
1770140845	148	208	236	236	166
1770140819	147	208	236	236	168
1770140809	147	209	225	229	167
1770140805	147	209	224	212	158
1770140785	147	208	236	229	165
1770139899	147	208	236	223	171
1770139859	147	209	225	223	172
1770139794	147	209	225	235	164
1770139329	145	209	225	221	168
1770136153	149	208	216	213	165
1770136053	149	209	217	220	167
1770135395	148	209	217	234	174
1770135232	147	209	224	212	162

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)