APRS Track Direct

My position About ☰

reset

SP9RUT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9RUT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770459315	78 Count	48 Count	4 Count
1770458113	54 Count	34 Count	2 Count
1770456910	34 Count	21 Count	1 Count
1770456309	21 Count	14 Count	0 Count
1770455111	679 Count	1004 Count	112 Count
1770454506	668 Count	997 Count	111 Count
1770453306	647 Count	981 Count	110 Count
1770452707	635 Count	972 Count	109 Count
1770452105	623 Count	965 Count	108 Count
1770451505	612 Count	958 Count	108 Count
1770450299	588 Count	944 Count	106 Count
1770449698	579 Count	938 Count	106 Count
1770449097	567 Count	930 Count	105 Count
1770448496	555 Count	926 Count	104 Count
1770447895	544 Count	921 Count	104 Count
1770446693	520 Count	905 Count	102 Count
1770446092	511 Count	900 Count	102 Count
1770445490	499 Count	893 Count	101 Count
1770444889	487 Count	886 Count	100 Count
1770444291	476 Count	879 Count	100 Count
1770443687	465 Count	872 Count	99 Count
1770443085	453 Count	863 Count	98 Count
1770442484	444 Count	855 Count	98 Count
1770441886	432 Count	844 Count	97 Count
1770441282	420 Count	838 Count	96 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)