APRS Track Direct

My position About ☰

reset

ED5YAS Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED5YAS. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732310010	116	125	10	143	38
1732309830	116	125	10	143	38
1732309649	116	126	20	143	38
1732309468	116	125	14	143	38
1732309288	116	126	27	143	38
1732309107	116	126	13	143	38
1732308927	116	126	34	143	38
1732308746	116	126	12	143	38
1732308566	116	125	32	143	38
1732308385	116	126	12	143	38
1732308204	116	125	18	143	38
1732308024	116	125	43	143	38
1732307843	116	126	42	143	38
1732307662	116	126	34	142	38
1732307482	116	125	36	143	38
1732307302	116	126	50	143	45
1732307121	116	126	48	143	38
1732306940	116	126	78	143	38
1732306760	116	126	53	143	38
1732306579	116	126	31	143	38
1732306398	116	126	68	143	38
1732306218	116	126	59	143	38
1732306037	116	126	51	143	38
1732305856	116	126	64	143	38
1732305676	116	126	45	143	38

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)