APRS Track Direct

My position About ☰

reset

SP3HUO-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3HUO-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770438495	392 Count	34 Count	22 Count
1770436694	388 Count	34 Count	22 Count
1770434893	384 Count	34 Count	22 Count
1770433092	380 Count	34 Count	22 Count
1770431315	376 Count	34 Count	22 Count
1770429514	372 Count	34 Count	22 Count
1770427713	368 Count	34 Count	22 Count
1770425912	364 Count	34 Count	22 Count
1770424111	359 Count	34 Count	22 Count
1770422310	355 Count	34 Count	22 Count
1770420509	351 Count	34 Count	22 Count
1770418708	346 Count	34 Count	22 Count
1770416907	342 Count	34 Count	22 Count
1770415106	338 Count	34 Count	22 Count
1770413305	334 Count	34 Count	22 Count
1770411504	330 Count	34 Count	22 Count
1770409703	326 Count	34 Count	22 Count
1770407902	322 Count	34 Count	22 Count
1770406101	318 Count	34 Count	22 Count
1770404301	314 Count	34 Count	22 Count
1770402500	310 Count	34 Count	22 Count
1770400699	306 Count	34 Count	22 Count
1770398898	302 Count	34 Count	22 Count
1770397097	298 Count	34 Count	22 Count
1770395296	288 Count	34 Count	22 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)