APRS Track Direct

My position About ☰

reset

VK2BLR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK2BLR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*
1750265627	136	54	13	5
1750265265	136	54	13	5
1750264904	136	54	13	5
1750264542	136	54	13	5
1750264178	136	54	13	5
1750263815	136	54	13	5
1750263453	136	54	13	6
1750263093	136	54	13	6
1750262731	137	54	13	6
1750262374	136	54	13	6
1750262008	136	54	13	6
1750261651	136	54	13	6
1750261285	136	54	13	6
1750260924	136	54	13	6
1750260563	136	54	13	6
1750260203	137	54	13	5
1750259842	136	54	13	5
1750259480	137	54	14	5
1750259117	136	54	14	6
1750258754	136	54	14	6
1750258393	136	54	14	6
1750258030	136	54	14	6
1750257669	136	54	14	6
1750257305	136	54	14	6
1750256944	136	54	14	6

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)