APRS Track Direct

My position About ☰

reset

KJ4KFJ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KJ4KFJ-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1770391969	134	103	255	80	67
1770391365	134	102	255	80	67
1770390764	134	101	255	81	68
1770390163	134	100	255	82	69
1770389562	134	99	255	82	69
1770388961	134	98	255	82	69
1770388360	134	98	255	83	70
1770387759	134	98	255	83	70
1770387156	134	98	255	83	70
1770386554	134	98	255	83	70
1770385951	134	98	255	83	70
1770385350	134	98	255	83	70
1770384749	134	98	255	83	70
1770384148	134	98	255	83	70
1770383547	134	97	255	83	70
1770382946	134	96	255	83	71
1770382345	134	96	255	84	71
1770381744	134	96	255	83	71
1770381142	134	96	255	83	70
1770380541	134	97	255	83	70
1770379940	134	97	255	83	70
1770379339	134	97	255	83	70
1770378738	134	97	255	83	70
1770378137	134	97	255	83	70
1770377536	134	97	255	83	70

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)