APRS Track Direct

My position About ☰

reset

W4KEL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W4KEL-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*
1754137999	13.74	22.57
1754137922	14.84	22.57
1754137892	13.74	22.57
1754137819	14.01	22.57
1754137686	13.98	22.09
1754137017	14.01	21.61
1754137004	13.95	21.61
1754136944	13.98	21.61
1754136914	13.83	21.61
1754136884	14.01	21.61
1754136630	14.01	21.12
1754136614	14.72	20.64
1754136601	14.75	20.64
1754136533	14.01	20.15
1754136436	14.01	19.67
1754135965	13.19	17.73
1754135817	12.97	16.77
1754135730	13.19	16.28
1754135677	13.1	15.8
1754135647	13.19	15.8
1754135636	13.16	15.8
1754135636	13.13	15.31
1754135630	13.16	15.8
1754135603	13.16	15.8
1754135581	14.96	14.35

*Used Equation Coefficients:

Value1: 0, 0.0306, 0

Value2: 0, 0.484, -273.15

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)