APRS Track Direct

My position About ☰

reset

IZ0IIY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ0IIY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*
1774119671	419	33
1774118769	419	33
1774117868	420	33
1774116968	419	33
1774116068	418	33
1774115168	419	33
1774114268	419	33
1774113367	419	33
1774112467	419	33
1774111567	419	33
1774110667	419	33
1774109776	419	33
1774108861	419	33
1774107961	419	33
1774107067	419	33
1774106161	419	33
1774105260	419	33
1774104360	419	33
1774103460	419	33
1774102560	419	33
1774101660	418	33
1774100759	419	33
1774099859	418	33
1774098959	419	33
1774098059	419	33

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)