APRS Track Direct

My position About ☰

reset

ZS1DCC-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ZS1DCC-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1770102743	128	30	134	113	107
1770102143	128	29	133	113	108
1770101542	128	29	133	113	108
1770100942	128	29	133	113	108
1770100341	128	29	134	113	108
1770099741	128	27	134	114	109
1770099141	128	26	134	114	110
1770098539	128	26	134	114	110
1770097939	128	25	134	115	111
1770097339	128	24	134	115	111
1770096739	128	24	134	115	111
1770096139	128	24	134	115	112
1770095539	128	23	134	115	112
1770094939	128	23	134	115	112
1770094339	128	23	134	116	112
1770093139	128	23	134	116	112
1770091939	128	23	134	116	112
1770090738	128	23	134	116	112
1770090138	128	23	134	116	112
1770089538	128	23	134	115	112
1770088938	128	23	134	116	112
1770088338	128	23	134	116	112
1770087738	128	23	134	116	112
1770087138	128	23	134	116	112
1770086538	128	23	134	115	112

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)