APRS Track Direct

My position About ☰

reset

ZL2BCA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ZL2BCA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*
1754263301	141	240	255
1754260884	140	240	255
1754260078	140	240	255
1754259271	140	240	255
1754258465	140	240	255
1754257658	140	236	255
1754256852	140	225	255
1754256046	140	223	255
1754254433	139	217	255
1754253626	139	215	255
1754252820	139	212	255
1754252013	139	211	255
1754251207	139	209	255
1754250400	139	208	255
1754249594	139	208	255
1754247981	139	208	255
1754245561	139	207	255
1754201206	141	211	255
1754195561	141	218	255
1754194754	141	219	255
1754193948	141	215	255
1754193141	142	216	255
1754191529	142	221	255
1754186690	145	231	255

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)