APRS Track Direct

My position About ☰

reset

GJ8RRP-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object GJ8RRP-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274448	123	107	255	88	80
1778061341	123	98	255	93	85
1778060440	123	98	255	93	88
1778059539	123	98	255	93	86
1778058638	123	98	255	93	89
1778057737	123	98	255	93	89
1778056836	123	98	255	93	86
1778055935	123	98	255	92	85
1778055038	123	98	255	93	86
1778054133	123	98	255	93	85
1778053232	123	98	255	93	89
1778052331	123	98	255	93	89
1778051430	123	98	255	93	89
1778050529	123	98	255	93	89
1778049628	123	98	255	93	86
1778048727	123	98	255	93	90
1778047826	123	98	255	93	86
1778046925	123	98	255	93	91
1778046024	123	98	255	93	86
1778045123	123	98	255	93	86
1778044222	123	98	255	93	86
1778043321	123	98	255	93	86
1778042420	123	98	255	93	86
1778041519	123	98	255	93	89
1778040618	123	98	255	93	86

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)