APRS Track Direct

My position About ☰

reset

N0KFB-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N0KFB-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790635996	134	110	999	371	237
1790635694	133	109	999	371	238
1790635393	135	109	999	371	238
1790635092	134	109	999	370	236
1790634791	134	108	999	376	243
1790634490	123	107	999	377	245
1790634189	122	108	999	376	244
1790633888	134	107	999	376	243
1790633587	123	107	999	377	245
1790632684	134	109	999	373	240
1790613015	135	98	999	396	266
1790612713	134	96	999	400	271
1790612412	121	96	999	406	276
1790612111	123	96	999	405	275
1790611810	124	96	999	404	274
1790611510	136	96	999	401	271
1790611209	136	95	999	403	273
1790610908	122	94	999	409	279
1790610607	137	94	999	407	278
1790610306	122	92	999	414	285
1790610005	125	92	999	414	285
1790609703	119	90	999	417	287
1790609102	121	89	999	423	294
1790608800	105	89	999	424	295
1790607596	139	86	999	424	296

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)