APRS Track Direct

My position About ☰

reset

DG8AAC-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG8AAC-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732289901	151	175	221	225	173
1732283974	155	213	224	211	161
1732283888	155	212	217	233	161
1732283877	155	213	224	225	163
1732283827	155	213	225	233	175
1732283759	155	213	224	211	161
1732283669	155	213	224	225	171
1732283618	155	213	225	233	179
1732283570	155	212	219	235	181
1732283500	156	213	224	225	172
1732283190	155	213	225	233	177
1732282980	155	213	225	233	177
1732282867	155	213	225	233	179
1732282751	155	213	225	233	175
1732282653	153	211	224	225	167
1732282485	155	213	225	219	175
1732282425	153	211	224	225	163
1732282399	153	211	224	225	169
1732282222	152	211	223	243	171
1732282147	153	211	224	225	169
1732282123	152	211	223	242	167
1732282089	151	211	223	229	175
1732281961	151	209	223	243	176
1732281936	151	211	223	229	169
1732281911	151	211	223	229	173

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)