APRS Track Direct

My position About ☰

reset

KB5ZUR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KB5ZUR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1766214210	127	77	255	103	80
1766212262	127	79	255	114	89
1766211365	127	80	255	103	81
1766210501	127	80	255	114	88
1766207794	144	75	255	117	91
1766199011	127	77	255	103	81
1766198358	127	77	255	115	90
1766197456	127	78	255	115	89
1766196555	127	79	255	114	89
1766195654	127	80	255	113	88
1766194750	127	82	255	113	88
1766193849	128	82	255	112	87
1766192948	127	83	255	102	80
1766192695	127	83	255	111	86
1766191792	127	84	255	111	86
1766190891	141	86	255	110	85
1766189988	142	86	255	110	85
1766189083	142	86	255	110	85
1766188182	142	86	255	110	85
1766187282	128	85	255	110	86
1766186381	128	85	255	110	85
1766185480	127	86	255	110	86
1766184579	128	85	255	110	85
1766183678	126	86	255	109	84
1766182776	143	86	255	110	85

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)