APRS Track Direct

My position About ☰

reset

F1ZIN-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1ZIN-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1778007614	734 Count	200 Count	157 Count
1778005810	733 Count	200 Count	157 Count
1778004006	732 Count	199 Count	157 Count
1778002201	731 Count	199 Count	157 Count
1778000397	730 Count	199 Count	157 Count
1777998593	729 Count	199 Count	157 Count
1777996789	728 Count	199 Count	157 Count
1777994985	727 Count	199 Count	157 Count
1777993181	709 Count	182 Count	140 Count
1777991376	708 Count	182 Count	140 Count
1777989572	697 Count	172 Count	130 Count
1777987768	696 Count	171 Count	130 Count
1777986012	691 Count	170 Count	130 Count
1777984208	689 Count	169 Count	129 Count
1777982404	672 Count	153 Count	113 Count
1777980600	671 Count	153 Count	113 Count
1777978795	661 Count	144 Count	104 Count
1777976991	660 Count	144 Count	104 Count
1777975187	659 Count	144 Count	104 Count
1777973383	658 Count	144 Count	104 Count
1777971579	657 Count	143 Count	104 Count
1777969774	656 Count	143 Count	104 Count
1777967970	654 Count	142 Count	103 Count
1777966165	651 Count	140 Count	101 Count
1777964408	646 Count	140 Count	101 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)