APRS Track Direct

My position About ☰

reset

DO7DH-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DO7DH-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Battery*	RSSI*
1790643303	13.5 V	-74 dBm
1790643023	13.5 V	-73 dBm
1790642705	13.5 V	-73 dBm
1790642431	13.5 V	-74 dBm
1790642152	13.5 V	-73 dBm
1790641858	13.5 V	-74 dBm
1790641557	13.5 V	-73 dBm
1790641249	13.5 V	-74 dBm
1790640950	13.5 V	-73 dBm
1790640623	13.5 V	-73 dBm
1790640332	13.5 V	-74 dBm
1790640044	13.5 V	-75 dBm
1790639742	13.5 V	-74 dBm
1790639409	13.5 V	-74 dBm
1790639161	13.5 V	-74 dBm
1790638852	13.5 V	-73 dBm
1790638527	13.5 V	-74 dBm
1790638236	13.5 V	-73 dBm
1790637905	13.5 V	-74 dBm
1790637636	13.5 V	-74 dBm
1790637310	13.5 V	-74 dBm
1790637033	13.5 V	-73 dBm
1790636739	13.5 V	-75 dBm
1790636430	13.5 V	-73 dBm
1790636157	13.5 V	-73 dBm

*Used Equation Coefficients:

Battery: 0, 0.1, 0

Brightness: 0, 1, 0

RSSI: 0, -1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)