APRS Track Direct

My position About ☰

reset

KF5BCX-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KF5BCX-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1744997992	137	92	255	89	73
1744996179	139	96	255	86	70
1744994376	140	100	255	83	67
1744992574	145	101	255	83	66
1744990765	144	100	255	84	67
1744987169	144	95	255	87	71
1744981659	137	86	255	92	78
1744974444	128	68	255	102	91
1744963555	128	72	255	100	88
1744959942	129	73	255	100	88
1744958137	130	73	255	100	87
1744956331	129	70	255	94	78
1744954468	130	75	255	99	86
1744950858	130	76	255	98	86
1744949053	130	75	255	98	86
1744947244	131	76	255	98	85
1744945436	131	76	255	98	85
1744943631	131	77	255	97	84
1744941825	131	75	255	88	71

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)