APRS Track Direct

My position About ☰

reset

SP3PSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3PSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770105482	73 Count	350 Count	66 Count
1770103681	52 Count	234 Count	46 Count
1770101881	36 Count	95 Count	31 Count
1770100088	18 Count	54 Count	18 Count
1770098287	406 Count	1010 Count	376 Count
1770096486	378 Count	934 Count	349 Count
1770094686	363 Count	895 Count	335 Count
1770092885	349 Count	856 Count	322 Count
1770091084	332 Count	809 Count	306 Count
1770089283	315 Count	763 Count	290 Count
1770087483	299 Count	719 Count	275 Count
1770085682	282 Count	675 Count	259 Count
1770083881	263 Count	626 Count	241 Count
1770082080	248 Count	587 Count	227 Count
1770080280	235 Count	546 Count	215 Count
1770078487	215 Count	503 Count	200 Count
1770076687	195 Count	457 Count	181 Count
1770074886	178 Count	417 Count	165 Count
1770073085	162 Count	376 Count	150 Count
1770071284	146 Count	336 Count	135 Count
1770069484	129 Count	300 Count	119 Count
1770067683	112 Count	259 Count	103 Count
1770065882	95 Count	219 Count	87 Count
1770064081	80 Count	181 Count	73 Count
1770062280	63 Count	138 Count	57 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)