APRS Track Direct

My position About ☰

reset

HK7ALI-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HK7ALI-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786730870	159	255	62	36	36
1786730569	155	255	59	33	32
1786728535	162	255	51	23	23
1786728231	162	255	52	24	24
1786727930	161	255	55	27	27
1786727629	159	255	62	35	36
1786727302	161	255	54	27	27
1786727001	161	255	56	28	28
1786726700	160	255	58	31	31
1786726399	159	255	60	33	34
1786726095	158	255	63	38	38
1786725794	156	255	68	43	44
1786724765	150	255	60	34	33
1786667266	158	255	61	35	35
1786666965	158	255	64	39	39
1786666831	158	255	61	36	36
1786666530	158	255	63	37	37
1786666229	157	255	64	39	40
1786665925	156	255	68	43	44
1786665624	152	255	73	49	50
1786664921	156	255	66	40	41
1786664620	155	255	69	45	45
1786664319	151	255	76	52	54
1786663526	156	255	67	42	43
1786663219	154	255	72	48	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)