APRS Track Direct

My position About ☰

reset

YD2VMF-57 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YD2VMF-57. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1770183697	-68 dBm	12.18 V
1770183373	-67 dBm	12.06 V
1770183048	-68 dBm	11.73 V
1770182723	-66 dBm	12.02 V
1770182398	-65 dBm	12.18 V
1770182074	-66 dBm	12.8 V
1770181749	-66 dBm	12.57 V
1770181425	-67 dBm	12.3 V
1770181101	-68 dBm	11.61 V
1770180776	-70 dBm	12.22 V
1770180453	-71 dBm	12.35 V
1770180128	-67 dBm	12.1 V
1770179804	-69 dBm	11.85 V
1770179479	-70 dBm	11.75 V
1770179155	-72 dBm	11.98 V
1770178831	-72 dBm	11.83 V
1770178506	-70 dBm	11.46 V
1770178182	-69 dBm	11.94 V
1770177857	-73 dBm	11.65 V
1770177532	-71 dBm	11.59 V
1770177208	-71 dBm	12 V
1770176883	-73 dBm	11.61 V
1770176559	-72 dBm	10.48 V
1770176234	-66 dBm	10.54 V
1770175910	-76 dBm	10.48 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)