APRS Track Direct

My position About ☰

reset

KQ6DI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*
1758213595	505	751	658	59
1758211793	494	715	657	59
1758210919	489	707	656	59
1758209993	483	700	655	59
1758208189	483	695	654	63
1758207318	483	695	653	59
1758206387	483	694	652	60
1758204585	483	695	651	60
1758203719	483	696	650	59
1758202783	483	696	649	59
1758200982	478	699	648	59
1758200119	483	700	647	59
1758199179	483	701	646	59
1758197377	483	704	645	59
1758196519	489	706	644	60
1758195575	489	708	643	59
1758193773	494	710	642	59
1758192918	494	714	641	59
1758191971	489	716	640	59
1758190170	494	723	639	59
1758189318	494	726	638	59
1758188366	499	731	637	59
1758186566	505	738	636	60
1758185719	505	743	635	62
1758184764	505	748	634	64

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)