APRS Track Direct

My position About ☰

reset

VA7LKM-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VA7LKM-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Temp*	V input*	Sol A*
1782620071	15 C	12.6 Volt	0.2 mA
1782618269	16.5 C	12.7 Volt	0.2 mA
1782616468	17 C	12.7 Volt	0.2 mA
1782614666	17 C	12.9 Volt	0.2 mA
1782611062	20 C	13.5 Volt	0.2 mA
1782609261	21 C	13.8 Volt	0.2 mA
1782607459	23.5 C	14.1 Volt	0.2 mA
1782605014	23.5 C	13.6 Volt	0.2 mA
1782589444	25 C	13.6 Volt	0.2 mA
1782578631	20 C	14.2 Volt	0.2 mA
1782576829	20.5 C	13.6 Volt	0.2 mA
1782573226	17 C	12.8 Volt	0.2 mA
1782571424	17.5 C	12.6 Volt	0.2 mA
1782569622	16 C	12.5 Volt	0.2 mA
1782567821	12.5 C	12.4 Volt	0.2 mA
1782566019	9.5 C	12.4 Volt	0 mA
1782564217	5.5 C	12.3 Volt	0 mA
1782562415	2.5 C	12.2 Volt	0 mA
1782561515	2 C	12.2 Volt	0 mA

*Used Equation Coefficients:

Temp: 0, 0.5, -62

V input: 0, 0.1, 0

CDS : 0, 0.1, 0

Sol A: 0, 0.1953, -24.803

U2: 0, 0.1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)