APRS Track Direct

My position About ☰

reset

TA1BE Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TA1BE. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	RSSI*	Voltage*
1732308426	-82 dBm	0.18 V
1732307696	-77 dBm	0.29 V
1732306966	-84 dBm	0.33 V
1732306235	-86 dBm	0.29 V
1732305506	-85 dBm	0.33 V
1732304776	-85 dBm	0.33 V
1732304046	-86 dBm	0.29 V
1732303315	-84 dBm	0.18 V
1732302585	-83 dBm	0.33 V
1732301856	-79 dBm	0.25 V
1732301126	-84 dBm	0.29 V
1732300395	-83 dBm	0.33 V
1732299666	-79 dBm	0.29 V
1732298935	-82 dBm	0.29 V
1732298206	-86 dBm	0.37 V
1732297476	-81 dBm	0.29 V
1732296745	-85 dBm	0.37 V
1732296015	-85 dBm	0.33 V
1732295286	-80 dBm	0.25 V
1732294556	-83 dBm	0.21 V
1732293825	-80 dBm	0.18 V
1732293097	-81 dBm	0.29 V
1732292365	-80 dBm	0.18 V
1732291636	-81 dBm	0.33 V
1732290905	-86 dBm	0.33 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)