APRS Track Direct

My position About ☰

reset

HS7ZSX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS7ZSX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	Voltage*
1774140918	-81 dBm	0.16 V
1774138929	-82 dBm	0.04 V
1774136942	-82 dBm	0.16 V
1774134952	-82 dBm	0.16 V
1774132964	-82 dBm	0.16 V
1774130976	-82 dBm	0.14 V
1774128988	-82 dBm	0.18 V
1774126999	-82 dBm	0.16 V
1774125010	-83 dBm	0.14 V
1774123022	-83 dBm	0.16 V
1774121034	-83 dBm	0.18 V
1774119046	-82 dBm	0.02 V
1774117056	-84 dBm	0.04 V
1774115068	-82 dBm	0.16 V
1774112989	-82 dBm	0.02 V
1774111000	-83 dBm	0.14 V
1774109012	-82 dBm	0.14 V
1774107024	-79 dBm	0.16 V
1774105035	-83 dBm	0.14 V
1774103047	-82 dBm	0.16 V
1774101058	-83 dBm	0.14 V
1774099070	-83 dBm	0.16 V
1774097082	-83 dBm	0.04 V
1774095093	-82 dBm	0.06 V
1774093105	-81 dBm	0.16 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)