APRS Track Direct

My position About ☰

reset

PY5TH-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY5TH-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732274137	30	68	761	4	147
1732273233	31	66	761	4	147
1732272326	31	65	760	4	147
1732271421	29	69	760	4	147
1732270516	27	78	760	4	147
1732269612	27	79	760	4	147
1732268702	26	80	759	4	147
1732267795	26	81	759	4	147
1732266888	26	82	759	4	147
1732265982	26	82	759	4	147
1732265074	26	83	758	4	147
1732264166	26	83	758	4	147
1732263259	25	83	758	4	147
1732262352	26	83	758	4	147
1732261443	26	83	757	4	147
1732260534	26	83	757	4	147
1732259628	26	81	757	4	147
1732258720	26	81	757	4	147
1732257814	26	81	756	4	147
1732256005	-	-	-	-	-
1732255089	27	78	756	4	147
1732254176	27	78	754	4	147
1732253269	27	78	754	4	147
1732252361	27	78	754	4	147
1732251455	27	77	754	4	147

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)