APRS Track Direct

My position About ☰

reset

VE6SLP-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE6SLP-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1770436727	133	32	73	41	48
1770429525	133	30	72	64	49
1770427724	133	33	71	41	48
1770425924	133	33	72	40	49
1770425025	133	31	72	41	48
1770422323	133	30	72	41	48
1770421423	133	31	99	41	48
1770420521	133	29	71	41	48
1770419622	133	36	72	66	49
1770418722	133	33	71	66	48
1770417822	133	31	69	40	49
1770416922	134	32	72	41	48
1770412420	133	33	71	41	48
1770409719	133	30	96	42	48
1770408819	133	30	72	41	48
1770407919	133	29	71	41	48
1770406118	133	31	70	41	48
1770404318	133	33	70	66	48
1770401616	133	32	102	41	49
1770400716	133	31	73	41	48
1770398917	133	30	73	41	49
1770398016	133	29	73	41	48
1770397115	133	31	73	41	48
1770396216	133	32	72	41	48
1770392614	133	30	72	41	49

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)