APRS Track Direct

My position About ☰

reset

PY5LF-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY5LF-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1751657313	117	139	106	119	113
1751657012	118	143	131	119	114
1751656711	118	142	118	119	114
1751656411	119	143	127	119	114
1751656108	119	143	119	120	114
1751655807	120	143	120	120	114
1751655506	120	145	133	120	115
1751655206	120	145	141	120	115
1751654903	121	146	145	120	113
1751654603	121	145	136	120	113
1751654302	121	145	134	120	114
1751654001	121	146	140	121	114
1751653701	123	149	148	121	116
1751653400	126	153	153	121	118
1751653100	123	149	148	121	115
1751652799	123	150	149	122	116
1751652499	124	151	151	122	117
1751652198	124	150	149	122	116
1751651895	125	151	150	123	119
1751651595	127	154	154	124	120
1751651294	129	157	156	125	122
1751650992	133	161	161	127	126
1751650691	135	164	164	128	128
1751650391	135	171	171	132	134
1751650090	126	153	152	124	120

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)