APRS Track Direct

My position About ☰

reset

SM0PQB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0PQB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1770102196	15 Count	140 Count
1770100393	14 Count	129 Count
1770098591	13 Count	118 Count
1770096787	12 Count	106 Count
1770094984	11 Count	94 Count
1770093181	10 Count	83 Count
1770091378	9 Count	71 Count
1770089575	8 Count	59 Count
1770064401	100 Count	903 Count
1770062598	99 Count	890 Count
1770060794	98 Count	880 Count
1770058991	97 Count	868 Count
1770057188	96 Count	856 Count
1770055385	95 Count	844 Count
1770053582	94 Count	832 Count
1770051779	93 Count	820 Count
1770049976	92 Count	809 Count
1770048173	91 Count	797 Count
1770046370	90 Count	785 Count
1770044601	85 Count	771 Count
1770042798	84 Count	761 Count
1770040995	83 Count	748 Count
1770039191	82 Count	737 Count
1770035585	80 Count	715 Count
1770031979	78 Count	690 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)