APRS Track Direct

My position About ☰

reset

9ATEST-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 9ATEST-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1774099934	150	168	207	230	139
1774099812	150	169	215	230	145
1774099750	150	168	208	239	151
1774099689	150	168	207	230	138
1774099628	150	169	215	230	139
1774099566	150	168	207	230	139
1774099444	150	168	208	239	152
1774099382	150	168	208	239	152
1774099321	150	169	215	230	140
1774099260	150	168	208	239	152
1774099199	150	169	215	230	144
1774099137	150	169	214	223	149
1774099076	150	169	215	230	144
1774099014	150	168	208	238	146
1774098891	150	169	214	229	143
1774098830	150	168	207	230	140
1774098582	150	168	208	238	145
1774098521	150	168	208	239	151
1774098459	150	169	215	230	145
1774098398	150	169	215	230	144
1774098337	150	169	214	223	147
1774098212	150	168	208	239	153
1774098151	150	168	208	239	153
1774098027	150	168	208	239	151
1774097966	150	169	215	230	139

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)