APRS Track Direct

My position About ☰

reset

K9DOM Telemetry

This is the latest recevied telemetry packets stored in our database for station/object K9DOM. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1779826345	70	107	255	88	40
1779826044	70	106	255	88	41
1779825743	71	107	255	88	40
1779825442	71	106	255	89	41
1779824540	71	105	255	90	41
1779823035	71	103	255	91	43
1779822734	71	102	255	92	43
1779822132	71	101	255	93	44
1779821831	71	100	255	94	45
1779821229	70	92	255	74	35
1779814619	70	106	255	89	39
1779814320	70	105	255	90	40
1779814017	70	105	255	90	40
1779813716	71	104	255	90	40
1779813414	71	104	255	91	41
1779812813	71	103	255	91	41
1779812512	71	102	255	91	41
1779812212	71	102	255	92	42
1779811609	71	100	255	92	43
1779811307	71	99	255	92	43
1779811007	71	98	255	93	44
1779810705	70	98	255	93	44
1779810405	71	97	255	93	45
1779809803	71	96	255	93	46
1779808900	71	94	255	94	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)