APRS Track Direct

My position About ☰

reset

F6ZBY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6ZBY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1770124592	313 Count	838 Count
1770122791	312 Count	834 Count
1770120991	311 Count	833 Count
1770119190	310 Count	831 Count
1770117389	309 Count	824 Count
1770115589	308 Count	822 Count
1770113788	307 Count	820 Count
1770111987	306 Count	818 Count
1770110187	305 Count	816 Count
1770108392	304 Count	815 Count
1770106591	303 Count	813 Count
1770104790	302 Count	812 Count
1770102990	301 Count	810 Count
1770101189	300 Count	808 Count
1770099388	299 Count	806 Count
1770097587	298 Count	804 Count
1770095787	297 Count	802 Count
1770093986	296 Count	799 Count
1770092185	295 Count	796 Count
1770090384	294 Count	794 Count
1770088584	293 Count	793 Count
1770086807	292 Count	792 Count
1770084994	291 Count	791 Count
1770083194	290 Count	789 Count
1770081393	289 Count	787 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)