APRS Track Direct

My position About ☰

reset

XE1GUU-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE1GUU-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1782517710	136	38	999	218	119
1782514159	136	38	999	218	119
1782510609	136	37	999	220	121
1782507058	136	37	999	221	123
1782503508	136	37	999	222	125
1782499957	136	37	999	221	123
1782496407	135	37	999	223	125
1782492856	136	37	999	223	125
1782489306	136	37	999	222	124
1782485755	136	37	999	222	125
1782482205	136	37	999	222	125
1782478654	136	37	999	223	125
1782475104	135	37	999	223	126
1782471553	135	36	999	228	130
1782468003	136	37	999	223	125
1782464452	136	36	999	228	131
1782460902	136	36	999	226	128
1782457351	136	35	999	232	137
1782453800	136	34	999	236	142
1782450250	136	34	999	234	139
1782446699	136	36	999	228	131
1782443149	136	36	999	225	128
1782439598	136	36	999	228	131
1782436048	136	37	999	223	125

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)