APRS Track Direct

My position About ☰

reset

PU1PZP-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PU1PZP-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786729204	23	65	101	17	138
1786728590	23	65	101	14	138
1786727981	24	65	101	19	138
1786727365	23	65	101	32	138
1786726732	23	66	101	18	138
1786726112	23	67	100	25	138
1786725487	23	68	100	18	138
1786724872	23	68	100	15	138
1786724259	23	68	100	15	138
1786723646	23	68	100	21	138
1786723024	23	69	100	16	138
1786722414	23	69	99	20	138
1786721798	23	69	99	26	138
1786721176	22	70	99	22	138
1786720556	22	70	99	22	138
1786719937	22	72	99	20	138
1786719323	-	-	-	-	-
1786718711	22	70	98	19	138
1786718092	22	70	98	26	138
1786717467	22	70	98	16	138
1786716849	22	70	90	23	138
1786716228	22	70	90	37	138
1786715591	22	70	89	14	138
1786714982	22	70	89	18	138
1786714365	22	70	89	38	138

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)