APRS Track Direct

My position About ☰

reset

DC1MU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DC1MU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1770082896	672 Count	922 Count
1770081092	671 Count	921 Count
1770079289	670 Count	919 Count
1770077485	669 Count	915 Count
1770075682	668 Count	915 Count
1770073879	667 Count	914 Count
1770072114	666 Count	914 Count
1770070311	665 Count	914 Count
1770068508	664 Count	914 Count
1770064901	662 Count	914 Count
1770063097	661 Count	911 Count
1770061294	660 Count	910 Count
1770059490	659 Count	910 Count
1770057687	658 Count	910 Count
1770055884	657 Count	910 Count
1770054080	656 Count	909 Count
1770052277	655 Count	909 Count
1770050514	654 Count	909 Count
1770048711	653 Count	909 Count
1770046907	652 Count	909 Count
1770045104	651 Count	909 Count
1770043301	650 Count	909 Count
1770041497	649 Count	909 Count
1770039694	648 Count	909 Count
1770037890	647 Count	909 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)