APRS Track Direct

My position About ☰

reset

F4GMT-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GMT-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1790675949	126 Count	240 Count
1790675047	125 Count	237 Count
1790674147	124 Count	235 Count
1790673246	123 Count	232 Count
1790672345	122 Count	230 Count
1790671445	121 Count	227 Count
1790670543	120 Count	225 Count
1790669643	119 Count	222 Count
1790668742	118 Count	220 Count
1790667842	117 Count	217 Count
1790666941	116 Count	215 Count
1790665944	111 Count	212 Count
1790665043	110 Count	210 Count
1790664143	109 Count	207 Count
1790663241	108 Count	205 Count
1790662340	107 Count	202 Count
1790661440	106 Count	200 Count
1790660539	105 Count	197 Count
1790659638	104 Count	195 Count
1790658738	103 Count	192 Count
1790657836	102 Count	190 Count
1790656936	101 Count	187 Count
1790656035	100 Count	185 Count
1790655134	99 Count	182 Count
1790654233	98 Count	180 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)