APRS Track Direct

My position About ☰

reset

WCSAR-8 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WCSAR-8. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Vin*	Temp*
1750203263	14.48 Volt	10.5 C
1750201462	14.48 Volt	10 C
1750199662	14.1 Volt	10.5 C
1750197859	14.4 Volt	11 C
1750196056	14.48 Volt	11 C
1750194256	14.4 Volt	11 C
1750192453	14.55 Volt	11.5 C
1750190653	14.55 Volt	12 C
1750188849	15.38 Volt	11 C
1750187048	15 Volt	12 C
1750183444	15.3 Volt	11.5 C
1750179842	14.78 Volt	11 C
1750178040	14.03 Volt	9.5 C
1750176239	13.65 Volt	8 C
1750174436	13.5 Volt	8 C
1750172635	13.43 Volt	8 C
1750170832	13.35 Volt	7.5 C
1750169030	13.35 Volt	6.5 C
1750167231	13.28 Volt	5 C
1750165429	13.2 Volt	5 C
1750163625	13.2 Volt	4.5 C
1750161825	13.2 Volt	4 C
1750160023	13.2 Volt	2.5 C
1750136687	13.43 Volt	7.5 C
1750134885	13.5 Volt	8.5 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

U1: 0, 0.1, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

Temp: 0, 0.5, -64

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)