APRS Track Direct

My position About ☰

reset

IR3UJH-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IR3UJH-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790646713	132	95	255	95	76
1790646112	132	95	255	95	77
1790645509	132	95	255	95	76
1790644907	130	95	255	96	76
1790644307	130	95	255	95	76
1790643704	132	94	255	96	77
1790643098	130	94	255	96	77
1790642494	132	94	255	96	77
1790641893	132	94	255	96	77
1790641291	132	94	255	96	77
1790640683	132	94	255	96	77
1790640081	132	93	255	100	81
1790639827	132	96	255	95	76
1790639226	130	96	255	95	76
1790638624	132	96	255	94	75
1790638023	132	96	255	94	75
1790637422	132	96	255	94	75
1790636820	132	97	255	94	74
1790636212	132	97	255	94	75
1790635611	130	97	255	94	74
1790635008	132	97	255	93	74
1790634402	132	98	255	93	74
1790633793	130	98	255	93	74
1790633188	132	98	255	93	74
1790632585	130	98	255	93	74

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)